Programming The Remote - Sony Bravia KF-42E200A Operating Instructions Manual

To connect Do this
Digital satellite Connect only to the HDMI IN
receiver or digital jack. The digital video and audio
terrestrial receiver signals are input from the digital
D
receiver.
Tip
If the digital receiver has an HDMI
jack, connecting via an HDMI cable
will provide the best results.
Notes
• When using an HDMI-to-DVI
cable or an adaptor, be sure to
connect the DVI output connector
first; then connect to the HDMI
jack on the TV.
• The HDMI jacks only support the
following video inputs: 480i,
480p, 576i, 576p, 720p and 1080i.
To connect a PC, use the PC IN
jacks.
• Be sure to use only an HDMI cable
that bears the HDMI logo.
DVD player with Connect to the component jack
component output 1, 2 and the audio jacks
E
1, 2. For better picture quality,
component connection is
recommended if your DVD player
has a component output.
DVD recorder or Connect to the video output jacks
VCR F
to record the image from the
TV. Connect to the audio output
jacks
from the TV on the DVD recorder
or VCR. To turn off the sound of
the TV speakers, set "Speaker" to
"Off" (page 30).
Video game Connect to the S video jack
equipment,VCR, or or the video jack
DVD player audio jacks
without component picture noise, do not connect the
output GH
camcorder to the video jack
and the S video jack
same time. If you connect mono
equipment, connect to the L
(MONO) jack
Hi-Fi audio Connect to the audio output jacks
equipment I
to listen to the sound from the
TV on the Hi-Fi audio equipment.
To turn off the sound of the TV
speakers, set "Speaker" to "Off"
(page 30).
to record to the sound
1
1, 3 and the
1, 3. To avoid
1
1 at the
1, 3.
Programming the
remote
If you have Sony VCRs/DVDs and Sony DVD Home
Theater Systems/Amplifiers, do the following
procedure to program the remote so that you can
operate them using this remote.
Note
Before you start, look up the three-digit code for your
equipment on page 44. For equipment that has more than one
code, try with the first code number.
1
Press and hold the DVD, VCR, or AMP
function button you want to program on the
remote and press the
simultaneously.
The selected function button (DVD, VCR, or
AMP) will flash.
2
Enter the three-digit code using the number
buttons while the function button is lit.
(approximately 10 seconds)
3
Press /-/-- or
programming.
When the programming is done successfully, the
selected function button will flash twice slowly, and
if not, will flash five times quickly.
1
2
3
1
/ button
to complete the
Continued
43
GB