KD-32DX100U
Thank you for purchasing this
Sony Trinitron Digital Television.
After following this step by step guide you will be
able to:
Insert batteries into the remote control.
Connect the aerial to your TV.
Connect a video cassette recorder (VCR) to
your TV.
Tune your TV.
View TV programmes.
4-206-495-01
Checking the supplied
1
accessories
The following accessories are included with your TV.
RF Loopthrough cable
Batteries
Remote Control
Inserting batteries into
2
the remote control
Insert the batteries as shown below.
1
2
Always remember to:
•
observe the correct polarity when inserting batteries,
•
dispose of batteries in an environmentally friendly way.
3
Connecting an aerial only
1 Connect your existing aerial lead to the Digital socket marked
the TV as shown.
2 Connect the supplied RF loopthrough cable from the sockets marked
Analogue socket marked
Connecting an aerial and a VCR
Scart lead
(not supplied)
1 Connect your existing aerial lead to the Digital socket marked
3
the TV as shown.
2 Connect the supplied RF loopthrough cable from the aerial socket marked
on the TV to the RF input socket of your VCR.
3 Connect an RF lead from the RF output of your VCR to the Analogue TV socket
marked
.
4 Connect a scart lead from the scart socket marked
TV to a scart socket on your VCR (Refer to the VCR instructions).
5 Connect the VCR to the mains socket and switch on.
6 Insert a pre-recorded tape into the VCR and press the 'PLAY' button. This
enables the TV set to locate and store the video channel during the
'Automatically tuning the TV' procedure.
Connecting the TV
Existing aerial lead
RF Loopthrough
cable (supplied)
on the rear of
.
Existing aerial lead
RF Loopthrough
cable (supplied)
RF Lead
(not supplied)
Rear of VCR
on the rear of
3/
3
on the rear of the
s
to the