Assembly Tools Required:
Adjustable Crescent Wrench
13mm Box Wrench or Socket
16mm Box Wrench or Socket
18mm Box Wrench or Socket
Step 1: Attaching Column Tube to the Receiver Tube
The Column Tube is attached to the Receiver Tube
using one 12mm x 80mm hex bolt, flat washer and
locknut, and the 12mm curved clevis pin. Attach the
Column Tube as shown in figure 1.
12mm hex bolt securely, then reverse the nut until
the column tube is free to rotate.
Column Tube
Figure 1
Step 2: Rack Assembly
Position the port and starboard brackets onto the center of
the cooler rack rear tube as shown in figure 2. Attach the
brackets using two 8mm x 55mm hex bolts, washers and
locknuts. Finger tighten only. Attach this assembly to the
column tube at the desired position and secure using one
10mm x 70mm hex bolt, washer and locknut as shown in
Figure 3. Tighten securely, then reverse the nut until the
brackets rotate freely on the column tube. Now securely
tighten the two 8mm x 55mm bracket bolts.
10mm Washer and
Locknut this side
Tighten the
12mm Washer and
Locknut this side
Receiver Tube
12mm x 80mm Hex Bolt
12mm Clevis Pin & Cotter Pin
Stack-Rack
Vertical Receiver Mounted Cargo Rack
Assembly and Use Instructions
Stack-Rack Parts Overview
General Purpose
Rack
Tie-Down Rings
Cooler Rack
Starboard Bracket
10mm x 70mm
Hex Bolt
Step 3: Repeat Step 2 for the general
Figure 3
purpose rack. Position the general purpose
rack at the desired location on the column
tube and secure using the same procedure in
Step 2.
Column Tube
Port Mounting
Bracket (2)
Starboard Mounting
Bracket (2)
Receiver Clevis
Pin Hole
Receiver Tube
Port Bracket
Figure 2
8mm x 55 mm
Hex Bolt