Sound
Problem
No sound, but good picture
Noisy sound
Channels
Problem
The desired channel cannot be
selected
Some channels are blank
Digital channels are not
displayed
General
Problem
The TV turns off automatically
(the TV enters standby mode)
The TV turns on automatically
Some input sources cannot be
selected
The remote does not function
Cause/Remedy
• Press 2 +/– or % (Mute).
• Check that "Speaker" is set to "On" in the "Set-up" menu (page 32).
• See "Picture noise" causes/remedies on page 48.
Cause/Remedy
• Switch between digital and analogue mode and select the desired digital/
analogue channel.
• Scrambled/Subscription only channel. Subscribe to the Pay Per View
service.
• Channel is used only for data (no picture or sound).
• Contact the broadcaster for transmission details.
• Contact a local installer to find out if digital transmissions are provided in
your area.
• Upgrade to a higher gain aerial.
Cause/Remedy
• Check if the "Sleep Timer" is activated, or confirm the "Duration" setting of
"On Timer" (page 31).
• If no signal is received and no operation is performed in the TV mode for
10 minutes, the TV automatically switches to standby mode.
• Check if the "On Timer" is activated (page 31).
• Select "AV Preset" in the "AV Set-up" menu and cancel "Skip" of the input
source (page 33).
• Check that the remote is set correctly for the equipment you are using.
• Check whether the equipment you want to use corresponds to the function
button being pressed (page 14).
• If the remote does not operate the equipment even when the remote has been
set correctly to the equipment, enter the necessary code as explained in
"Programming the remote" (page 44).
• Replace the batteries.
49
GB