In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: Chain Block Model: CT0346 CT0347 Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards EN ISO 13157 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K.
INTRODUCTION This chain block is for lifting not pulling. SPECIFICATION Stock No......CT0346......CT0347 Load .........1000kgs......2000kgs Lift height ......2.5M ......3M Hand force (when fully loaded N) ... 304......314 Weight ....... ..9kgs......13kgs HANDLING & STORAGE Take care when handling and lifting.
- Never use a chain block or any other overhead lifting equipment for lifting persons. - Never use a chain block in wet, explosive or corrosive enviroments. UNPACKING & CHECKING PACKAGING After removing the packing material, make sure the product is in perfect condition and that there are no visible damaged parts.
HEALTH & SAFETY INFORMATION Always ensure that the product is fully inspected before every use, this will prevent damage or serious injury to person. FREQUENT INSPECTION A visual inspection is to be carried out by a trained person before every use. This inspection should consist of: - Evidence of slippage on the braking mechanisms.
NOTE: The ambient operating temperature of this chain block is between –10° C and +50° C. MOUNTING THE CHAIN HOIST (Fig.1.): Ensure that the hook sits over the holding beam of a secure beam clamp or dolly. The secure latch should be in the closed position once the unit is hung.
Page 8
Hoist Capacity Replace hook when the opening is greater than 1000kgs 28.6mm 2000kgs 38.5mm GAUGING LOAD CHAIN WEAR (Fig.3.): To determine if the load chain should continue to Be used. Check the gauge lengths as shown. Chain wornbeyond length indicated, severely nicked, gouged or twisted should be replaced before using the chain block again.
Page 10
Part Description Part Description Part Description Load Chain Hand Chain Stay B Suspension Plate Pawl Spring Hook Hanger Stay A Pawl Bent Plate Load Chain Wheel Hand Chain Wheel Cover Roller Drive Shaft Snap Ring Gear Cover Gear Pawl Pin Shaft Pinion Shaft Left Side Plate...
Page 12
CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. Made in China...