Kidde Truesense Combo User Manual page 19

To activate the battery carrier tamper resist feature, remove the unit from
the mounting bracket, disconnect the AC quick connector and locate
the small cut-out in the middle of the label on the back of the unit. With
a small screwdriver, or similar tool, slide the switch towards the "LOCK"
position as shown on the label(see Figure 9-F). The tamper resist feature
is now active and the battery carrier can not be opened until the tamper
resist feature is deactivated.
NOTE:
Before activating the battery carrier tamper resist feature, make
sure a fresh battery is installed in the unit and that the battery carrier is
properly closed. If the battery carrier tamper resist feature is activated while the battery carrier is open, the
battery carrier will not close and the unit will be inoperable during the loss of AC power.
To deactivate the battery carrier tamper resist, in order to change the smoke alarm battery, remove the unit
from the mounting bracket (see Smoke Alarm Tamper Resist Feature if activated), disconnect the AC quick
connector and locate the small cut-out in the middle of the back label. Using a screwdriver, or similar tool, slide
the switchin the opposite direction of the "LOCK" arrow as shown on the label. The battery carrier can now be
opened and the battery changed.
aC wired interconnect Model Capability
This model has AC hardwire interconnect capability. When one hardwired interconnect unit sounds an alarm,
all other compatible hardwire or interconnected units will also alarm.
•
The following models can be interconnected using the standard AC wiring interconnect: 1235, 1275, 1276,
1285, i12020, i12020A, i12040, i12040A, i12060, i12060A, i12080, i12080A, i4618, i4618A, i4618AC, KN-SMFM-I,
RF-SM-ACDC, PE120, P12040, Pi2000, Pi2010, KN-COSM-I, KN-COSM-IB, KN-COSM-IBA, KN-COPE-I,
KN-COPE-IC, KN-COB-IC, KN-COP-IC, SL177i, SLED177i, HD135F, SM120X, CO120X, i12010S, i12010SCO,
P4010ACSCO, P4010ACSCO-W, P4010LACS-W, P4010ACS, P4010ACS-W, 2070-VASCR, 2070-VASR,
P4010ACLEDS-2, P4010ACLEDSCO-2.
The alarm is now activated! After installation / activation, test your alarm as described in Operation and
Testing section.
waRNiNG: FaiLURE TO pROpERLy iNSTaLL aNd aCTiVaTE THiS aLaRM wiLL pREVENT
pROpER OpERaTiON OF THiS aLaRM aNd wiLL pREVENT iTS RESpONSE TO FiRE HazaRdS.
Figure 9- F
19