Step 5: Preparing The Remote; Controlling Tvs With The Remote - Sony SVR-S500 Operating Instructions Manual

Step 5: Preparing the
Remote
You can control the recorder using the supplied
remote. Insert two R6 (size AA) batteries by
matching the 3 and # ends on the batteries to the
markings inside the battery compartment. When
using the remote, point it at the remote sensor
on the recorder.
b
Notes
• If the supplied remote interferes your other Sony Hard
Disk recorder, change the command mode number for
this recorder (page 12).
• Use the batteries correctly to avoid possible leakage
and corrosion. Do not touch the liquid with bare hands
should leakage occur. Observe the following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an extended
period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid inside
the battery compartment, and insert new batteries.
• Do not expose the remote sensor (marked
front panel) to strong light, such as direct sunlight or
lighting apparatus. The recorder may not respond to the
remote.

Controlling TVs with the remote

You can adjust the remote's signal to control your
TV.
b
Notes
• Depending on the connected unit, you may not be able
to control your TV with some or all of the buttons
below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the code
number may be reset to the default setting. Set the
appropriate code number again.
Number
buttons
TV VOL
+/–
TV PROG
+/–
1
on the
Hold down the TV dedicated [/1 button
located at the bottom of the remote.
Do not press the [/1 button at the top of the
remote.
TV [/1
TV/VIDEO
11
, continued