Connecting A Vcr Or Similar Recording Device To The Line3 Jack - Sony RDR GX7 Hookups And Settings

Controlling the volume of your AV
amplifier (receiver) with the remote
a Slide the TV/DVD switch to DVD.
b Hold down [/1, and enter the manufacturer
code (see the table below) for your AV
amplifier (receiver) using the number
buttons.
c Release [/1.
The 2 (volume) +/– buttons control the AV
amplifier's volume.
If you want to control the TV's volume
Slide the TV/DVD switch to TV.
Hint
z
If you want to control the TV's volume even when the TV/DVD switch
is set to DVD, repeat the steps above and enter the code number 90
(default).
Code numbers of controllable AV amplifiers
(receivers)
If more than one code number is listed, try entering them one at
a time until you find the one that works with your AV amplifier
(receiver).
Manufacturer
Sony
Denon
Kenwood
Onkyo
Pioneer
Sansui
Technics
Yamaha
Note
If you cannot control the volume of your Sony AV amplifier (receiver)
with the remote, try entering the code number 91, and change the
command mode of your amplifier (receiver) to "COMMAND MODE
[AV1]" (not all amplifiers have this option).
See the instructions supplied with your amplifier (receiver) to change the
command mode.
22

Connecting a VCR or Similar Recording Device to the LINE3 Jack

Code number
80, 88, 89, 91
84, 85, 86
92, 93
81, 82, 83
99
87
97, 98
94, 95, 96
Connecting a VCR or
Similar Recording Device
to the LINE3 Jack
You can use this recorder as the source player or as the recording
deck. See "Recording From Equipment Connected to the LINE
IN Jacks" in the separate booklet "Operating Instructions"
when connecting to the LINE 2 IN or LINE 4 IN jacks.
Disconnect the recorder's mains lead from the mains when
connecting the VCR or recording device.
How to connect to record
Connect a VCR or similar recording device to the LINE 3/
DECODER jack of this recorder. Then press INPUT SELECT to
select "L3." You are ready to start recording.
If you are using this recorder as the recording deck, see
"Recording from Equipment Connected to the LINE IN jacks" in
the separate booklet "Operating Instructions."
If you are using this recorder as the source player, refer to the
instructions of the connected device for recording instructions.
to SCART
(EURO AV) input
SCART (EURO AV)
cord (not supplied)
to i to i LINE
LINE1-TV 3/DECODER
LINE 1 - TV LINE 3/DECODER
AERIAL
IN
COAXIAL
LINE 4 IN LINE 2 OUT
OUT R-AUDIO-L VIDEO S VIDEO R-AUDIO-L VIDEO
OPTICAL
DIGITAL OUT
PCM/DTS/MPEG/
DOLBY DIGITAL
Hint
z
If you are using another recorder with S VIDEO and AUDIO IN/OUT
jacks, you can connect those jacks to this recorder's S VIDEO and R-
AUDIO-L IN/OUT jacks.
Notes
• If you pass the recorder signals via the VCR, you may not receive a
clear image on the TV screen.
DVD recorder
• SMARTLINK features are not available for devices connected via the
DVD recorder's LINE 3/DECODER jack.
• Pictures containing copy protection signals that prohibit any copying
cannot be recorded.
TV
VCR
DVD recorder
~
AC IN
Y
C
S VIDEO B
C R
COMPONENT
VIDEO OUT
VCR TV