Makita BKP180Z Technical Information page 8

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-4. Front Base, Base, Foot (cont.)
ASSEMBLING
(1) Assemble Foot to Base (rear) before assembling Base to Main frame. (Fig. 12)
Assemble Base with Foot to Main frame by taking the disassembling step in reverse. (Refer to Fig. 11)
Fig. 12
1. Pass Long pin of Foot through
Torsion spring 7.
Long pin
Torsion spring 7
of Foot
Foot
(2) Assemble Font base to Main frame. Then adjust the planing depth to zero. (Fig. 13)
Fig. 13
3. Assemble Front base to pass
its Threaded pole through
Main frame and Knob.
Knob
Compression
Main
spring 18
frame
Threaded pole
Front base
Rubber packing
6. While holding M10 Hex nut on Threaded pole of
Main frame with Knob cover functioning as Socket
wrench temporarily, align the indication "0" on Knob
to the triangle mark on Main frame.
And them, remove Knob cover.
Triangle
mark
Knob cover
2. Facing Torsion spring 7 side to the opposite side of Belt cover side,
assemble Foot to Base (rear) with putting Torsion spring's tail
on the Base.
Torsion spring 7
4. Set M10 Hex nut to Threaded
pole of Front base. And engage
Knob cover with M10 Hex nut.
M10
Hex nut
Threaded pole
Base
Knob
0
Hook this tail
with Base.
Foot
Belt cover side
5. Turn Knob cover clockwise until
the surfaces of Front base and
Base contact the rule completely.
Planing depth will be set at the
Knob cover zero level by the above adjustment.
Front base
7. Assemble Retaining ring S-8 to Threaded pole
of Front base.
And install Knob cover by pressing to Knob.
Knob cover
Retaining
ring S-8
P 8/ 10
Belt cover side
Knob cover
Base