Remote Access With Qt/Dqt; Clear To Transpond (Remote Control); Function Port Window; Aux Select Tab - Kenwood TKR-750 Programming Reference Manual

6.9.3

Remote Access with QT/DQT

It can receive the Air Remote code depending on the
matched/unmatched status of the received QT/DQT
code.
TKR-750/850/751/851 receives the
Air Remote code only when the QT/
DQT code matches. Although the it
Checked
performs the repeat operation, it does
not transmit when "TX Disable" is
enabled.
Range
TKR-750/850/751/851 receives the
Air Remote code even when the QT/
DQT code does not match or carrier. It
Unchecked
cannot enable the repeat operation
when the repeat conditions do not
match.
Default Unchecked
Note:
! This function is only available to receive the Air Remote code.
This function does not affect the repeat operation.
! If the check box is checked, the QT/DQT Decode function is
performed to receive the Air Remote code even when the QT/
DQT Decode function is disabled as following.
• The Off-hook Decode function is disabled and the
microphone is in the Off-hook position.
• The monitor is enable:
6.9.4 Clear To Transpond (Remote
Control)
This is a timing to transmit a Transpond code. If check
box is checked, TKR-750/850/751/851 waits to transmit a
Transpond code until the channel is available.
Waits until the channel becomes
available without sending the
Checked
Transpond code when the channel is
Range
busy.
Sends the Transpond code even if the
Unchecked
channel is busy.
Default Unchecked
Version: 1.01

6.10 Function Port Window

It can configure the functions that you can assign to the
Auxiliary port on this window. This window consists of
"AUX Select" and "AUX" tabs and it can switch the
window by clicking the tabs.

6.10.1 AUX Select Tab

It can select operation type of AUX Input/Output ports on
this window.
" Function (AUX Select)
It can assign this function to the AUX Input/Output
ports 1 - 6 only. Select a operation type from "AUX
Input", "AUX Output", "Channel Select", and "Multi-
table Select".
Range
Default
Note:
! It can assign "Channel Select" and the "Multi-table Select" to
! It cannot change the order of the AUX Input/Output ports (1 -
Field Programming Reference (FPRG)
Figure 6-19 AUX Select tab
AUX Input This port works as the PF Input port.
AUX Output This port works as the PF Output port.
Move to one of the CH 1 - CH 16
Channel channels when the voltage level of the
Select Auxiliary Input/Output pots is High or
Low.
Specify one of the No. 2 to No. 16
Multi-table codes configured on the Multi-table
Select when the voltage level of the Auxiliary
Input/Output ports is High or Low.
AUX Input/Output 1 - 5: AUX Input
AUX Input/Output 6: AUX Output
the AUX Input/Output ports 1 - 4 only.
4) when assigning the "Channel Select" function to these
ports. If the AUX Input/Output 1" port is assigned the "Multi-
table Select", the "Multi-table Select" function is
automatically assigned to AUX Input/Output ports (2 - 4).
6 EDIT MENU
48