Sony Cyber-shot DSC-S40 Service Manual page 4

Insert the Shutter Assembly Cable
The next step is to insert the S40 Shutter
Assembly cable into the shutter connector.
Locate the shutter connector shown in Figure
4. Using a small pair to tweezers with smooth
jaws carefully remove the cable from this
connector. Carefully grab the base of the
ribbon cable and take your time to remove
this cable.
Next insert the S40 Shutter cable, which will
be sandwiched in with the current cable.
Insert the cable in the orientation as shown in
Figure 5. Be sure to align the properly and
use your tweezers to push both cables into
the connector.
Once inserted add a small piece of electrical
tape to keep the cable in place as shown in
figure 6.
Figure 4
Figure 5