Replacing Belt - Hoover Rewind Instruction Manual

Keep your Rewind Running Properly: Replacing Belt
The belt is located under the cover of the vacuum and should be checked often. Replace belt if it stretched, cut or broken.
1
2
Lower handle and
vacuum flip over.
CAUTION
To reduce the risk
of injury from moving parts
- Unplug
before servicing.
Any other servicing should be done by an authorized service representative. If appliance is not working as it should,
has been dropped, damaged, left outdoors, or dropped into water, take it to a service center prior to continuing use.
3
Remove (6) screws on Remove worn belt
bottom plate with a and slide new belt
Phillips screwdriver. with lettering on the
Pivot off the outside over the motor
bottom plate. shaft.
4
Push other end of new
belt around brushroll
area without bristles.
What to buy: Belt
If desired, additional belts can be purchased at Hoover.com or 1-800-944-9200.
When purchasing a new belt for models ask for Hoover
5
Replace bottom plate
and reinsert screws.
Belt part No. 38528058
®
16