Step 5: Turn On The Monitor And Computer; Adjusting The Tilt; Selecting The Input Signal (Input Button) - Sony SDM-HS95P/R Operating Instructions Manual

Step 5: Turn on the monitor and
computer
1
Press the 1 (power) switch upward.
The 1 (power) indicator of the monitor lights up in green.
2
Turn on the computer.
The installation of your monitor is complete. If necessary, use the
monitor's controls to adjust the picture.
If no picture appears on your screen
• Check that the power cord and the video signal cable are
properly connected.
• If NO INPUT SIGNAL appears on the screen:
The computer is in the power saving mode. Try pressing any
key on the keyboard or moving the mouse.
• If CABLE DISCONNECTED appears on the screen:
Check that the video signal cable is properly connected.
• If OUT OF RANGE appears on the screen:
Reconnect the old monitor. Then adjust the computer's
graphics board within the following ranges.
Analog RGB
Horizontal
28–80 kHz
frequency
Vertical 48–75 Hz
frequency
1280 × 1024 or less 1280 × 1024 or less
Resolution
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 18.
No need for specific drivers
The monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.
Digital RGB
28–64 kHz
60 Hz

Adjusting the tilt

This display can be adjusted within the angles shown below.
Approx. 20°
Grasp the lower sides of the LCD panel, then adjust screen tilt.
To use the display comfortably
This display is designed so that you can set it up at a comfortable
viewing angle. Adjust the viewing angle of your display
according to the height of the desk and chair, and so that light is
not reflected from the screen to your eyes.
Note
When adjusting the screen tilt, make sure not to knock or drop the display
off the desk.
Selecting the input signal
(INPUT button)
Press the INPUT button.
The input signal change each time you press this button.
INPUT
On-screen message
(Appears about 5 seconds on
the upper left corner.)
INPUT1 : DVI-D
INPUT2 : HD15
Input signal configuration
DVI-D input connector
(digital RGB) for INPUT1
HD15 input connector
(analog RGB) for INPUT2
9
GB