Dimplex FPE 050E Installation And Operating Instructions Manual page 20

English
10. Options
10.1 Window monitoring
NOTE
The WINDOW MONITORING function is activated at
the factory.
The room heating device is equipped with a monitoring
function that detects whether unnecessary energy is
being consumed due to an open window.
In this case, the window symbol and the green
operating display flash. An acoustic warning signal
sounds and heating operation is stopped.
Pressing the WINDOW key continues heating
operation.
Activating / deactivating the function
Press and hold the WINDOW key for three
seconds.
The window symbol either appears or disappears
on the display.
10.2 Presence detection
NOTE
Presence detection only in automatic operation.
The controller detects whether a person is in the room.
The set comfort temperature remains active for as long
as a person is detected. If the room is not in use, the
temperature is lowered gradually to save energy:
- By 1°C after 30 minutes, display CF1.
- By 2°C after one hour, display CF2.
- By 3.5°C after more than 2 hours (factory setting).
As soon as a person is detected in the room, the switch
to comfort temperature takes place.
EN-9
10.3 Easy key lock
NOTE
If CLEF appears briefly after any key actuation, key
lock is active.
Blocking
Press and hold the + key and – key simultaneously
for three seconds. CLEF 1 appears briefly, the
BLOCK symbol is shown.
Unblocking
Press and hold the + key and – key simultaneously
for three seconds. CLEF 0 appears briefly, the
BLOCK symbol disappears.
10.4 Key lock with numerical code
Block key entry with a four-digit numerical code
1802/A
FPE 050E - FPE 200E
.
www.dimplex.de/en