Replacing The Brake Hose - Shimano BR-M8000 Dealer's Manual

MAINTENANCE

Replacing the brake hose

„ Replacing the brake hose
Brake lever side
If there is a marking as shown in the illustration, refer to the "How to replace the brake hose (easy hose joint
system)" section of General Operations.
1
(A)
(z)
2
To be continued on next page
Use a utility knife or other cutting tool
to cut the brake hose.
(z)
(z)
In order to check that the ends of the
(A)
brake hose are fitted securely into the
base of the brake hose mounts of the
brake calipers and brake lever, make
marks on the brake hose beforehand as
shown in the illustration.
(As a guide, the length of brake hose
inside the mount should be
approximately 11mm, measured from
the cut end of the brake hose.)
(z)
NOTE
90°
Approx. 11mm
30
Mark
NOTE
Use the utility knife safely and correctly in
accordance with its instruction manual.
TECH TIPS
If you are using TL-BH62, refer to the manual
accompanying the product.
(A)
Mark