Forward/Reverse Switch; Adjustable Torque; When Using The Drill/Driver For Drilling; Inserting And Removing Bits - ALDI 1956 User Manual

AUS
Operation

Forward/reverse switch

NOTE: You can only change the direction of rotation of the drill/driver using the
forward/reverse switch (5) when the trigger (7) is NOT depressed.
This switch will allow you to change the direction of the motor while the trigger
switch is not depressed.
Drill/driving uses the forward mode. The reverse mode is intended for the removal of
screws and assisting to remove jammed drill/driver bits.
When the forward/reverse switch (5) is in the middle position, the drill is in the lock
position and will not function.

Adjustable torque

This drill/driver is equipped with 21 torque settings plus 1 x drill setting.
The torque settings are controlled and adjusted by the torque setting collar (2).

When using the drill/driver for drilling

1. When using the drilling function the torque control has
no effect to the output of the drill.
The drill function is used when using the drill to
drill holes in metal, non ferrous material, wood, plastic
and similar materials.
Rotate the function selection collar so the symbol
of the drill bit aligns with the triangular indicator on
the top of the drill housing (Fig I).

Inserting and removing bits

This drill/driver has a keyless chuck, which means that a
chuck key is not needed to
secure a bit in the drill/driver.
1. Open the chuck (1) by unscrewing it in an anti-
clockwise direction, holding the drill/ driver as shown
(Fig J).
Do this sufficiently enough to allow the drill/ driver bit
18
e-mail: info.aldi@positecgroup.com
MODEL No.: CDT214XA • 05/2019 • 1956
16V Lithium-ion Cordless Drill
J.
OPEN
CLOSE
AFTER SALES SUPPORT
1300 889 028
AUS
(toll free)