Adjusting The Sound Characteristics; Quickly Attenuating The Sound - Sony CDX-F5005X Operating Instructions (primary manual) Operating Instructions Manual

Fm/am compact disc player
Hide thumbs Also See for CDX-F5005X Operating Instructions (primary manual):
Table of Contents

Advertisement

Available languages

Available languages

When an MP3 file is played, you can select an
album using the rotary commander.
(With optional unit)
To
Do this
Skip discs
Push in and rotate [once for
– Disc selection
each disc] the control.
To continuously skip discs,
push in and rotate once and
rotate again within 2
seconds (and hold) the
control.
Skip albums*
3
1 To enter Album selection
– Album selection
mode, push in, then rotate
and hold the control.
Within 2 seconds,
proceed to step 2.
2 Push in, then rotate
quickly and repeatedly, to
skip albums one by one.
*1 Only if the corresponding optional equipment is
connected.
*2 If your car has no ACC (accessory) position on the
ignition key switch, after turning off the ignition, be
sure to press and hold (OFF) until the display
disappears.
*3 Available only when an optional CD unit with the
MP3 file control function is connected, and MP3 file
is played.
Changing the operative direction
The operative direction of controls is factory-set
as shown below.
To increase
If you need to mount the rotary commander on
the right hand side of the steering column, you
can reverse the operative direction.
Press (SEL) for 2 seconds while
pushing the VOL control.
To decrease
Adjusting the sound
characteristics
You can adjust the balance, fader, low pass filter
and subwoofer volume.
1
Press (SEL) repeatedly until "BAL,"
"FAD," "LPF" or "SUB" appears.
Each time you press (SEL), the item changes
as follows:
1
t MID*
1
t HI*
LOW*
BAL (left-right) t FAD (front-rear) t
LPF (low pass filter)*
SUB (subwoofer volume)*
*1 When EQ3 is activated (page 19).
*2 When "SUB" is selected (page 18).
*3 The cut off frequency is adjustable to 78 Hz,
125 Hz, or OFF.
*4 The volume level is adjustable between –10
and +10 steps. (Below –10, "ATT" is displayed.)
2
Press the volume +/– button to adjust
the selected item.
Note
Adjust within 3 seconds after selecting the item.
Quickly attenuating the
sound
Press (ATT).
After "ATT-ON" momentarily appears,
"ATT" appears in the display.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes in
(Telephone ATT function).
1
t
2
3
t
*
2
4
*
17

Advertisement

Table of Contents
loading

Table of Contents