Suzuki Baleno Manual page 3014

8-4 BODY ELECTRICAL SYSTEM
COMBINATION SWITCH
Combination switch incorporates lighting, turn signal, hazard warning light, dimmer, passing light and
wiper/washer switches.
8-004
Inspection
1) Disconnect negative (–) cable at battery.
2) Disconnect combination switch lead wire connectors from
junction/fuse block.
3) Use a circuit tester to check the continuity at each switch
position. If any continuity is not obtained, replace switch.
Removal/ Installation
For removal/installation of combination switch, refer to Sec-
tion 3C or 3C1 of this manual.
NOTE:
Some vehicles are not provided with INTERMITTENT position
depending on specification.