Troubleshooting - Craftsman 917.20381 Operator's Manual

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM.......... C AUSE
Will not start 1 Out of fuel.
2 Engine not "CHOKED" properly.
3 Engine flooded.
,, ,,_
Hard to start
4 Bad spark plug.
5 Dirty air filter.
6 Dirty fuel filter.
7 Water in fuel.
J,,,,,,,,
Engine will not
turn over
8 Loose or damaged wiring.
9 Engine valves out of adjustment.
1 Dirty air filter.
2 Bad spark plug.
3 Weak or dead batter].
4 Dirty fuel filter.
5 Stale or dirty fuel
6 Loose or damaged wiring.
7 Engine valves out of adjustment.
1 Clutch/brake pedai not depressed.
2 Attachment clutch is engaged.
3 Weak or dead battery.
: 4 B]own fuse..
5 Corroded battery terminals.
6 Loose or damaged wiring.
i 7 Faulty ignition switch.
8 Faulty solenoid or starter.
g Faulty operator presence
switch(as).
CORRECTION
1 Fill fuel tank.
2 See "TO START ENGINE" in
Operation section.
3 Wait several minutes before
attempting to start.
4 Rep|ace spark plug.
5 CleanJrep]aee air filter,
6 Replace fuel filter.
7 Empty fuel tank and carburetor,
refiI| tank with fresh gasoline and
replace fuel filter.
8 Check all wiring.
9 Contact a Sears or other qualified
service center.
1 Clean/replace air fi]ter,
2 Replace spark plug.
3 Recharge or replace battery.
4 Replace fuel filter.
5 Empty fuel tank and refill tank witt"
fresh, clean gasoline.
6 Check alt wiring.
7 Contact a Sears or other qualified
service center.
1 Depress clutch/brake pedal.
2 Disengage attachment clutch.
3 Recharge or replace battery.
4 Replace fuse.
5 Clean battery terminals.
6 Check atl wiring.
7 Check/replace ignition switch.
8 Check/replace sotenoid or sta_er,
g Contact a Sears or other quat_fied
service center,
29