Table of Contents
Advertisement
4 – CD player—Repeat play
Clear the program by pressing
display shows
cleared when the disc tray is opened, and if the
key is pressed when playback is stopped in pro-
grammed order mode.
Repeat play
The unit can repeat the whole of the disc (or pro-
gram), an A–B portion set as described here, or the
current track only.
NOTE
Selecting the repeat mode is only possible using the
remote control unit. It is not possible to select the
repeat mode using the main unit alone.
1
The unit should be in playback, pause or stop
mode.
Continue to press the
display shows
Setting the A and B repeat points
While the
indicator is lit, you can set the
REPEAT A-B
points between which playback should loop.
1
Start playback before the point where you
want the loop to start.
2
Press the A-B key (remote control) at the
point where the loop is to start.
3
Press the A-B key once more at the point at
where the loop is to end.
Playback jumps back to the first (A) point
and continues to the second (B) point and
Intro check
This is a useful facility to skip through the first 10
seconds of all the tracks on a CD to refresh your
memory of the contents of the CD.
1
With the disc stopped, press the
key.
CHECK
The first 10 seconds of each track on the disc
will be played. Press
back process.
22
TASCAM CC-222 Owner's Manual
until the
PLAY MODE
. The program is also
STOP
REPEAT
key so that the
(the
REPEAT 1
INTRO
to stop this play-
STOP
The programmed play order is not memorized when
power is turned off.
If an attempt is made to enter more than 25 program
steps, the message
display.
indicator lights) to repeat one track,
(the
lights) to repeat the whole disc or program,
(the
lights) to repeat between two points as
explained below.
2
If playback has not started, restart it.
To cancel repeat mode, press the
the display shows
indicator goes out. Pressing
repeat mode.
then returns to the A point again, repeating
the loop.
Cancel the A-B repeat mode by pressing the
NOTE
If the A and B points are too close together, A-B looping
is not possible.
The A and B points can be on either side of a track divi-
sion, but there may be a gap in the loop during play-
back in this case.
Pressing
INTRO CHECK
again cancels the mode and
returns to normal playback.
NOTE
This function is only available from the remote control
unit. It is not possible to use this function with the main
unit only.
appears on the
indicator
REPEAT ALL
indicator
REPEAT A-B
key so that
REPEAT
and the
REPEAT
also cancels
STOP
key.
A-B
Advertisement
Table of Contents
