Partner Elite (PEKP) System Installation Manual

Partner Elite (PEKP) Keypad & Intercom Station

Installation Instructions

1. Introduction
The Partner Elite keypad is for use on
P-16128 v3.1 and higher. The Partner
Elite presents system status via a 32-
character liquid crystal display. Each
keypad is connected to the panel via the
4-wire Combus. In addition to regular
keypad functions, the Elite can be used
to initiate or receive pages, answer
incoming calls, answer the doorbell,
monitor rooms, or sound an alarm
follower. To use the audio portion of the
unit, each keypad must be home run to
the PC4936 audio interface module using shielded 22 gauge, 4 conductor wire.
2. Specifications
• Connects to control panel via 4-wire Combus
• Current draw (from Combus): 50mA (standby), 100mA (with backlighting boost)
• Current draw (from PC4936): 20mA (standby), 50mA (max.)
• Thirteen programmable function keys (Home, Away, Chime, T-Code, Cancel, A to H)
• Eight programmable two-color LEDs
• Three emergency keys (Fire, Auxiliary, Police)
• Four status lights: Ready-Arm, Interior, Trouble, and T-Code
• Built-in intercom station with speaker, microphone, Page/Answer button, and Quiet (do not
disturb) button
3. Installation
Unpacking
The Partner Elite package includes the following parts:
• One Partner Elite (PEKP) keypad
• Four mounting screws
• One inner-door sticker
Mounting
Mount the keypad where it is accessible to designated points of entry/exit. Once a dry and
secure location is selected, perform the following steps to mount the keypad:
1. 1. 1. 1. 1. Remove the keypad backplate by loosening the screw located at the base of the unit.
2. 2. 2. 2. 2. Secure the keypad backplate to the wall in the desired location. Use the screws provided.
Before mounting the keypad to its backplate, complete keypad wiring as described over.
Please refer to the System Installation Manual for information on limitations regarding product
use and function and information on the limitations as to liability of the manufacturer.
AUX