Inspection, Maintenance, And Cleaning - Chicago Electric 08886 Operating Instructions Manual

Power station
Table of Contents

Advertisement

electric system of the vehicle/boat. (See Figure B.)
6.
Turn the vehicle/boat ignition to "ON", and wait for one to two minutes.
7.
Turn the vehicle/boat ignition to "START" for no more than 5 to 6 seconds.
8.
NOTE: If the vehicle/boat engine does not start, turn the vehicle/boat ignition to
"OFF" and wait at least 3 minutes before repeating Steps #6 and #7.
9.
Once the vehicle/boat engine is running, disconnect the BLACK/NEGATIVE (-)
Clamp of the Copper Booster Cable (part #2) from the vehicle/boat Battery and
return the Clamp to its stored position on the Power Station. (See Figure B.)
10.
Disconnect the RED/POSITIVE (+) Clamp of the Copper Booster Cable (part #1)
from the vehicle/boat Battery and return the Clamp to its stored position on the
Power Station. (See Figure B.)
11.
As soon as possible, recharge the Power Station.
To Turn On The Emergency Light:
1.
To turn on the Emergency Light (part #8), simply depress the Emergency Light
Switch (part #6) to its "ON" position. Make sure the Emergency Light Switch is in
its "OFF" position when the Power Station is being stored. (See Figure B.)

INSPECTION, MAINTENANCE, AND CLEANING

1.
CAUTION: Before performing any inspection, maintenance, or cleaning, always
place the Voltage Select Switch (part #3) in its "OFF" position, place the
Emergency Light Switch in its "OFF" position, and make sure the Clamps of the
Copper Booster Cables (parts #1, #2) are in their stored positions,
2.
BEFORE EACH USE, inspect the general condition of the Power Station. Check
for loose screws, misalignment or binding of moving parts, cracked, bent or parts,
frayed Copper Booster Cables (parts #1, #2), and any other condition that may
affect its safe operation. If a problem occurs, have the problem corrected before
further use. Do not use damaged equipment.
3.
TO REPLACE THE EMERGENCY LIGHT BULB: Carefully squeeze the sides of
the plastic Light Case together and remove the Light Case and Light
Lens. Unscrew and remove the burned out Light Bulb and replace with a
SKU 08886
PAGE 10

Advertisement

Table of Contents
loading

Table of Contents