Uniden OCEANUS DSC/ATIS Technical Service Information

CONFIDENTIAL / Uniden Marine Dealers Only
TECHNICAL SERVICE INFORMATION
Brand : UNIDEN
1. MMSI
1A. After purchase the user can program, one time only, the MMSI in the radio.
This is described in the user manual.
1B. To reprogram the MMSI ID the radio needs to be serviced at a Uniden Marine
Dealer that has a RESET JIG. (also to reprogram ATIS ID)
This item can be purchased from Avera B.V. The Netherlands.
1C. Procedure to reset the radio for new MMSI ID:
1. Make sure power radio is off.
2. Connect the reset jig to the accessory cable of the radio.
(red arrows on connectors!)
3. Push and hold CH UP on the radio while turning power on.
4. If display reads: "MMSI ID CLR"
reset has been succesful and MMSI ID can be reprogrammed
5. If display reads: MMSI ID INIT
* the radio has not been initialized yet
* the reset jig is not connected properly
* the reset jig is broken
In this case: Put power off, wait some minutes and follow complete procedure
again. (See step 4)
Note: During testing the RESET JIG it happened that all MMSI numbers from the
directory were deleted!
2. ATIS ID
2A. How to program ATIS is not mentioned in the user manual !
2B.1. Situation "Out of the box":
Put power on
Press "menu""
Press "CH Down"
Press "Select"
Press 6x "CH Down (*1)
Press "Select"
The first number after "ID" is not blinking, than it is NOT possible to program an ATIS
number.
Type: OCEANUS DSC/ATIS
Display "DSC Call"
Display "SET UP"
Display "Directory"
Display "ATIS ID"
Display "AT " and "ID 000000000"
Revised june 7 – 2005