Sony NXCAM HXR-NX5N Operating Manual page 79

MONO
Outputs in monaural.
INT MIC SET
INT MIC SENS
x
You can set recording sensitivity of the
internal microphone.
B NORMAL
Sensitivity that is normally used in
professional recordings.
HIGH
Sensitivity that is normally used in
consumer recordings.
appears on the status check
screen.
INT MIC WIND
x
B OFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
XLR SET
XLR AGC LINK
x
You can select either linked or separate
AGC (Auto Gain Control) of CH1 and CH2
when using an external microphone.
B SEPARATE
Separately applies the AGC for CH1/CH2.
Sound inputs from CH1/CH2 will be
recorded as separate sound.
LINKED ( )
Applies the AGC of CH1 linked with that
of CH2. Sound inputs from CH1/CH2 will
be recorded as a set of sound such as stereo
A
sound. appears on the status check
screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to AUTO and the INPUT1
and INPUT2 switches are both set to MIC or
both set to LINE (p. 40).
AUDIO MANUAL GAIN
x
You can select either linked or separate
audio level control of CH1 and CH2 when
using an external microphone.
B SEPARATE
Separately controls the audio levels of
CH1 and CH2. Sound inputs from CH1
and CH2 will be recorded as separate
sound.
LINKED ( )
Controls the audio level of CH1 linked
with that of CH2. Sound inputs from CH1
and CH2 will be recorded as a set of sound
such as stereo sound.
status check screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to MAN and the INPUT1
and INPUT2 switches are both set to MIC or
both set to LINE (p. 40).
• When you select [LINKED], you can adjust the
volume with the AUDIO LEVEL dial of CH1
(p. 40).
x INPUT1 TRIM
You can adjust the input signal level from
INPUT1.
You can select from [-18dB], [-12dB],
[-6dB], [0dB], [+6dB] and [+12dB]. The
default setting is [0dB].
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
x INPUT1 WIND
B OFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
M appears on the
79
Continued ,