Clean Vacuum Pump Filter - TAWI VM30 User Manual

Clean vacuum pump filter

The vacuum pump filter should be cleaned regulary (once a week, more often if the environment re-
quires it).
1. Remove the filter unit from the filter holder (a).
2. Open the filter unit (b).
3. Empty the filter unit and remove the filter inset in an upside-down position (c).
4. Carefully clean the filter inset using reduced compressed air.
5. The filter inset MUST be replaced when dirty or damaged.
6. Reassemble the filter unit and mount it in the filter holder with the filter unit lid in the upward direc-
tion (see figure).
7. Verify function of the lifter.
a
• Clean the vacuum pump and suction foot filter regulary. Failure to clean the filters may cause the
pump to overheat or reduce lifting capacity.
• Take care to mount the filter unit in the correct orientation during reassembly. Damage to the
pump may occur if the filter unit is mounted upside-down in the filter holder.
18
b c