Sony Handycam HDR-HC1 Operating Manual page 54

PICT.APPLI. menu (Continued)
INT.REC-STL
(Interval photo recording)
You can record still images on the
"Memory Stick Duo" at a selected interval.
This function is useful to observe the
movement of clouds or the changes in
daylight, etc.
[a]: Recording
[b]: Interval

Touch

or 10 minutes)
.

Press PHOTO fully.
stops flashing and the interval still
image recording starts.
To cancel [INT.REC-STL], select [OFF]

in step .
SHOT TRANS
You can register the settings of focus and
zoom and then change the recording setting
from the current one to the registered one,
resulting in a smooth transition of scenes
(Shot transition).
SHOT B
STORE
Set the zoom (p. 26) and focus (p. 27) at
the desirable setting and press [STORE-
A]. [SHOT-A] flashes and will be
registered. Register [STORE-B] as well.
EXEC
Touch [NEXT]
54
a desired interval time (1, 5
[ON]
  
SHOT A
[EXEC-A] or [EXEC-

B] and the recording setting changes to
the registered one. Touch [BACK] to
register again or touch [END] to finish the
operation.
• You cannot register the setting while recording.
• It takes about 4 seconds to change to the
registered setting.
• If you register [SHOT TRANS], the [WHITE
BAL.] setting is also registered at the same
time.
• The recording angle varies during [SHOT
TRANS].
• Use the tripod because [STEADYSHOT] does
not function.
DEMO MODE

The default setting is [ON], allowing you
to view the demonstration in about 10
minutes, after you have removed both a
cassette and a "Memory Stick Duo" from
your camcorder, and slide the POWER
switch down to turn on the CAMERA-
TAPE lamp.
• The demonstration will be suspended in
situations such as those described below.
– When you touch the screen during the
demonstration. (The demonstration starts
again in about 10 minutes.)
– When a cassette or a "Memory Stick Duo" is
inserted.
– When the POWER switch is set to other than
CAMERA-TAPE.
PictBridge PRINT
See page 70.