Chamfering And Corner Rounding Commands - Siemens SINUMERIK 802D sl Programming Manual

Enhanced Level Commands
4.8 Program support functions (2)
Status at power- -on
Whether working area limitation is enabled or disabled at power--on is decided by
the following machine data:
$MC_EXTERN_GCODE_RESET_VALUES[3]
This MD is set to value 2 (G23) as default.
4.8.2

Chamfering and corner rounding commands

It is possible to insert chamfering and corner rounding blocks automatically bet-
ween the following items:
-- Linear interpolation and linear interpolation blocks
-- Linear interpolation and circular interpolation blocks
-- Circular interpolation and linear interpolation blocks
-- Circular interpolation and circular interpolation blocks
Format
, C...; Champfering
, R...; Corner rounding
Explanations
A chamfering or corner rounding block is inserted whenever the above specification
is added to the end of a block that specifies linear interpolation (G01) or circular
interpolation (G02 or G03). It is possible to specify blocks applying chamfering and
corner rounding consecutively.
4-144
SINUMERIK 802D sl/840D/840D sl/840Di/840Di sl/810D ISO Milling (PGM) -- 04.07 Edition
© Siemens AG 2007 All rights reserved
04.07