Sony DCR- Operating Instructions Manual page 110

Dubbing only desired scenes – Digital program editing (on tapes)
(4) Confirming VCR operation
When the VCR does not operate correctly
• After checking the code in "About the IR SETUP code," set IR SETUP or
PAUSEMODE again.
• Place your camcorder at least 30 cm (12 in.) away from the VCR.
• Refer to the operating instructions of your VCR.
110
1 Insert a recordable tape into the VCR, then set the VCR to recording pause.
2 Turn the SEL/PUSH EXEC dial to select IR TEST, then press the dial.
3 Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.
If the VCR starts recording, the setting is correct.
When recording is finished, the indicator changes to COMPLETE.
2
0 : 08 : 55 : 06
VIDEO EDIT
EDIT SET
CONTROL
ADJ TEST
"CUT–IN"
"CUT–OUT" ENGAGE
IR SETUP REC PAUSE
PAUSEMODE
IR TEST RETURN
RETURN EXECUTE
[ MENU ] : END
3
0 : 08 : 55 : 06
VIDEO EDIT
EDIT SET
CONTROL
ADJ TEST
"CUT–IN"
"CUT–OUT"
IR SETUP
PAUSEMODE
IR TEST COMPLETE
RETURN
[ MENU ] : END