Aux Input; Rca Jacks; Bluetooth Pairing; Additional Speaker - Gemini WRX-900TOGO User Manual

WRX-900TOGO
PORTABLE RECHARGEABLE LINE ARRAY
SPEAKER SYSTEM
BALANCED LINE LEVEL SOURCE
Mixer channels 1 and 2 on the rear panel
of the unit are used to connect balanced
line sources as well as
microphones. Switch the
channel to LINE level and
connect your device. This
type of connection would
typically be used to connect
professional gear like mixers
or electronic instruments.

AUX INPUT

Locate mixer channel 3/4 and fi nd
at the bottom a 3.5mm TRS Jack. This
type of connection is commonly used
to connect the unit to the headphones
output of a mobile device.
RCA INPUT
Just above the AUX Jack on mixer
channel 3/4 are the RCA jacks. This
type of connection is typically used to
connect devices like CD or DVD players.
Note: Left and right channels are color
coded white and red.

BLUETOOTH PAIRING

• The WRX-900TOGO can accept streaming
audio from any Bluetooth-equipped portable
device. First, make sure Bluetooth
is enabled on your portable
device. Locate channels 3/4 on
the back of the WRX-900TOGO
and press the BLUETOOTH
button. You will hear a tone and
a blue LED will begin to fl ash to
indicate the unit is in PAIRING mode.
• On your mobile device, search for a
Bluetooth device called "WRX-900TOGO"
and select it to pair. Once
pairing is complete, you will
hear another series of tones,
and the blue LED will light
solid. Your mobile device is now
connected and ready to stream
music.

ADDITIONAL SPEAKER

If you would like to connect
another speaker to the WRX-
900TOGO (for instance, another
WRX-900TOGO to form a stereo
pair), fi rst locate the MIC OUT
XLR Jack on the rear of the unit.
Connect a standard XLR cable
from the MIX OUT Jack to the
input of the additional speaker.
USING THE INTERNAL MIXER

MASTER VOLUME

The master volume is the main
volume control on the WRX-
900TOGO. Use it to control the
overall level of the WRX-900TOGO.

POWER/LIMIT LED

This LED is located directly underneath the
MASTER VOLUME knob. When the WRX-
900TOGO is powered on, this LED will light
green. While the unit is operational, if this
LED lights red that indicates the unit is being
overdriven and the volume should be turned
down immediately.

CHANNEL VOLUMES

At the top of each mixer
channel is the LEVEL or
VOLUME CONTROL for
that channel. These knobs
control the relative volume
of that channel only. So, if you wanted to
(for instance) lower the level of the AUX
T U O
L R
IN in relation to one of the microphones,
you would turn down the LEVEL of
channel 3.

MIC/LINE SWITCH

These switches, located under the
volume controls for channels 1 and
2, are used to set the input to the
appropriate level for the connected
device. If plugging in a mic, set the
switch to MIC (and vice versa).

REVERB SWITCH

On mixer channels 1 and 2 there is a
REVERB ON/OFF switch. When in the
ON position, a reverb eff ect is added
to that channel. This is commonly
used on microphones and acoustic
instruments to add more depth.
REVERB KNOB
This knob, located under the MASTER
VOLUME knob, controls the strength
of the reverb eff ect. Turning this knob
clockwise increases the strength of
the reverb.

DSP PRESETS

The WRX-900TOGO DSP is
like a computerized EQ with
presets. The PRESET DSP
button allows you to change
between music, live, Hi Fi or
speech presets.
5