Operating The Cooling Device Safely - Dometic CFF SERIES Operating Manual

Safety instructions
• If the cooling device is connected to a DC outlet: Disconnect the
cooling device and other power consuming devices from the battery
before connecting a quick charging device.
• If the cooling device is connected to a DC outlet: Disconnect the
cooling device or switch it off when you turn off the engine. Otherwise
you may discharge the battery.
• The cooling device is not suitable for transporting caustic materials or
materials containing solvents.
• The insulation of the cooling device contains flammable cyclopentane
and requires special disposal procedures. Deliver the cooling device
at the end of its life-cycle to an appropriate recycling center.
2.2

Operating the cooling device safely

!
CAUTION!
Failure to obey these cautions could result in minor or moderate injury.
ELECTROCUTION HAZARD
• Before starting the cooling device, ensure that the power supply line
and the plug are dry.
A
NOTICE!
DAMAGE HAZARD
• Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for the purpose.
• Do not place the cooling device near open flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
• OVERHEATING HAZARD
Ensure at all times that there is a minimum of 50 mm (2") ventilation on
all four sides of the cooling device. Keep the ventilation area free of
any objects that could restrict the air flow to the cooling components.
Do not place the cooling device in closed compartments or areas with
none or minimal air flow.
• Ensure that the ventilation openings are not covered.
• Do not fill the inner container with ice or liquids.
• Never immerse the cooling device in water.
• Protect the cooling device and the cable against heat and moisture.
• Protect the cooling device from exposure to rain.
6
CFF35, CFF45
EN