Table of Contents
Advertisement
Chapter 2
Installing the Base Station
Figure 12: Folding Back the Foil
1. Foil 2. Twisted-Pair Wires 3. Drain Wire
4.
Bend the drain wire back over the jacket.
Figure 13: Bending the Drain Wire
1. Foil 2. Drain Wire 3. Twisted-Pair Wires
5.
Partially untwist each wire pair, making sure to retain a half twist at the end.
Figure 14: Untwisting the Wire Pairs
6.
Arrange the wires according to the following pin-out description:
20
1
1
3
2
3
2
Assembling the PoE Connector
RUGGEDCOM WIN7237
Installation Guide
Advertisement
Table of Contents
