Miele EVS 6114 Operating And Installation Instructions page 25

 Place the vacuum adapter  over the
vacuum pump air intake valve .
 Attach the connector  to the
container lid. Make sure that the
closure of the lid is turned to
"seal" (closed).
 Switch the drawer on with the
 sensor.
The  and  sensors will light up.
 Touch the  sensor.
The  and  sensors go out. The
 and  sensors will light up.
 Touch the  sensor repeatedly until
the segment for the required vacuum
level lights up.
 Touch the  sensor.
The vacuuming process will start.
Leave the glass lid open for the
entire duration of the vacuuming
process.
If an excessive amount of bubbles
form you can cancel the vacuuming
process by pressing the  sensor
(see "Cancelling the vacuuming
process").
After the vacuuming process
An acoustic tone will sound.
 Detach the connector from the
container lid. Make sure that the
closure of the lid is still turned to
"seal" (closed).
 Remove the vacuum adapter from the
vacuum pump air intake valve.
Before starting a new vacuuming
process, check that the vacuum
adapter, the tube and the vacuum
chamber are clean and dry.
Remove any soiling or liquid residues
if necessary.
Operation
25