Advertisement
Table 1
Default Settings on the Express Setup Page (continued)
Setting
IP Address
IP Subnet Mask
Default Gateway
SNMP
SSID
Broadcast SSID in Beacon
Role in Radio Network
Optimize Radio Network for
1. During Install Mode, the SSID is autoinstall.
What To Do Next
After your bridge has basic settings, you need to complete your bridge's configuration. You might need
to adjust the output power level and other network and security settings.
Output Power Level
Your bridge's output power level might require adjustment under the following conditions:
• When bridges are installed less than 328 ft (100 m) apart, you should reduce their output power
to avoid overloading the bridge's receivers.
To configure your bridge's output power level, refer to the Power Levels and Channels for Cisco
Aironet Access Points and Bridges.
14
THIRD FCC DRAFT (CISCO CONFIDENTIAL)
Default
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 10.0.0.1
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 255.255.255.224
Assigned by DHCP (default setting); if DHCP is disabled, the
default setting is 0.0.0.0
defaultCommunity
Read Only
autoinstall
Yes
Install
Throughput
1
Advertisement
