Canon Color Network UFR Printer Kit-C1 Service Manual page 17

Non-default paper
User-defined paper
UFR/PS/PCL
- The height and width can be specified by 1/10 mm(Except US)or 1/100
inch(US).
- The height must be equal to or greater than width.
Area-Specific Paper Sizes
In addition to default paper sizes (A4/LTR) and user-defined paper sizes, the printer driver supports area-specific
paper sizes (e.g., Officio), and it handles these area-specific paper sizes as user-defined paper sizes, requiring the
user to register them in advance of use. To do so, see the instructions on registering user-defined paper sizes for
individual operating systems.
When an area-specific paper size is manually set up under [Form to Tray Assignment] of the driver UI, or if the
size obtained by running dynamic configuration happens to be an area-specific paper size, the driver operates in
the corresponding mode. After performing all associated internal operations, the driver runs a check of area-
specific paper sizes stored as user defined paper sizes, and handles any matching paper as a default paper size
(special paper ID) instead of as a user-defined paper size. Moreover, the driver permits registration of multiple
area-specific paper sizes, treating them as a separate paper group. The driver UI handles them using specifications
designed for LTR paper, permitting the use of finisher functions, which were previously offered for user-defined
paper sizes (except the use of the middle binding function). Although it will permit all settings, the printer unit
may ignore some of the settings. (The printer driver will simply ignore them, not issuing conflicts.)
Paper size
Govermment Letter
Govermment LetterR
Foolscap
Oficio
T-1-4
minimum 99.00×140.00 (13,860)
maximum 308.00×407.00 (125,356)
Note:
The value in parentheses indicates the area
in mm2.
T-1-5
G_LGR
G_LGL
FLSP
OFI
Dimensions
Feed direction Width
203.0 267.0
330.0 203.0
330.0 216.0
317.0 216.0
Chapter 1
1-5