MSI MS-7596 User Manual page 42

▍
MS-7596 Manboard
▶ Advance DRAM Configuraton
Press <Enter> to enter the sub-menu.
▶ DRAM Tmng Mode
Ths field has the capacty to automatcally detect all of the DRAM tmng. If you set
ths field to [DCT 0], [DCT 1] or [Both], some fields wll appear and selectable. DCT
0 controls channel A and DCT1 controls channel B.
▶ DRAM Drve Strength
Ths tem allows you to control the memory data bus' sgnal strength. Increasng the
drve strength of the memory bus can ncrease stablty durng overclockng.
▶ DRAM Advance Control
Ths field has the capacty to automatcally detect the advanced DRAM tmng. If you
set ths field to [DCT 0], [DCT 1] or [Both], some fields wll appear and selectable.
▶ 1T/2T Memory Tmng
Ths tem controls the SDRAM command rate. Select [1T] makes SDRAM sgnal
controller to run at 1T (T=clock cycles) rate. Selectng [2T] makes SDRAM sgnal
controller run at 2T rate.
▶ DCT Unganged Mode
Ths feature s used to Integrate two 64-bt DCTs nto a 128-bt nterface.
▶ Bank Interleavng
Bank Interleavng s an mportant parameter for mprovng overclockng capablty of
memory. It allows system to access multple banks smultaneously.
▶ Power Down Enable
Ths s a memory power-savng technology. When the system does not access mem-
ory over a perod of tme, t wll automatcally reduce the memory power supply.
▶ MemClk Trstate C3/ATLVID
Ths settng allows you to enable/dsable the MemClk Trstatng durng C3 and
ATLVID.
▶ FSB/DRAM Rato
Ths tem allows you to select the rato of FSB/ DRAM.
▶ Adjusted DRAM Frequency (MHz)
It shows the adjusted Memory frequency. Read-only.
▶ Onboard VGA Over Clock
Ths tem allows you to overclock the onboard VGA.
▶ Onboard VGA Clock
Ths tem wll appear when Onboard VGA Over Clock sets to [Enabled]. It allows you
to adjust the onboard VGA clock.
En-32