Troubleshooting - Snapper EZF2100DKU, EZF2300GKU, EZF5200M, EZF6100M Safety Instructions & Operator's Manual

PROBLEM
Tractor Will Not Move
Loss Of Traction
Blade(s) Not Cutting
Cutting Grass
Improperly
Poor Grass Discharge 1. Engine speed too slow.
Battery Will Not Charge 1. Poor cable connections.
Oil Leaking
Deck Will Not Lift
Properly

TROUBLESHOOTING

PROBABLE CAUSE
1. Joystick in the neutral "N" position.
2. Roll release lever is in "ROLL" position.
3. Low transmission hydraulic oil level.
4. Parking Brake engaged.
5. Traction drive belt requires replacement.
1. Blade engagement switch in the "OFF" position.
2. Clutch belt slipping.
3. Mower belt slipping.
4. Electric clutch not functioning.
5. Check gearbox for damage.
6. Power transfer shaft disconnected or damaged.
1. Uneven tire pressure.
2. Cutting height too low or high.
3. Engine speed too slow.
4. Forward speed too fast.
5. Terraced cut, side to side.
6. Excessive deck pitch, front to rear.
7. Cutting blade(s) dull or damaged.
8. Blade belt slipping.
9. Check electric clutch.
10. Check clutch belt.
11. Check gearbox for damage.
2. Forward speed too fast.
3. Grass is wet.
4. Excessively worn or damaged blade(s).
5. Build up of grass clippings and debris under deck.
6. Improper blade(s) installed on deck.
7. Blade(s) installed improperly on deck.
2. Bad battery cell(s).
3. Faulty alternator.
1. Loose or missing hydraulic reservoir cap.
2. Leaking hose fittings, clamps or reservoir.
1. Loose or disconnected electrical harness.
2. Electric screw jack malfunctioning.
3. Key switch is in "OFF" position.
1. Place joystick in desired speed position.
2. Move roll release lever to the engaged position.
3. Bring hydraulic oil to proper level.
4. Move parking brake to disengaged position.
5. Replace traction drive belt.
1. Move blade switch to the "ON" position.
2. Replace clutch belt.
3. Replace mower belt.
4. Contact authorized SNAPPER dealer.
5. Contact authorized SNAPPER dealer.
6. Connect power transfer shaft or repair damage.
1. Bring to proper pressure.
2. Adjust cutting height.
3. Move throttle control to "FAST" position.
4. Move joystick to a slower speed.
5. Adjust side to side level.
6. Adjust front to rear level.
7. Sharpen cutting edges or replace blade(s).
8. Replace blade belt.
9. Adjust to proper specifications.
10. Replace clutch belt.
11. Contact authorized SNAPPER dealer.
1. Move throttle control to "FAST" position.
2. Move joystick to a slower speed.
3. Mow when grass is dry.
4. Service mower blade(s).
5. Clean deck.
6. Install proper SNAPPER blades.
7. Install blades properly.
1. Clean cables and battery terminals.
2. Replace with new battery.
3. Contact engine manufacturer's dealer.
1. Check oil level and replace reservoir cap.
2. Verify fittings and hose clamps are tight.
1. Connect electrical harness.
2. Contact authorized SNAPPER dealer.
3. Turn key switch to "ON" position.
27
CORRECTIVE ACTION