Advertisement
(black) and 184-pin DDR DIMM (blue) can be easily distinguished by the fool-proof
design.
Please do not insert both 168-pin SDRAM DIMM and 184-pin DDR DIMM at the same time.
Only use one single type of DIMMs at one time. To optimize the compatibility it is not
recommended to use two different models of the DIMMs at the same time.
Installing a DIMM
Step 1.
Unlock a DIMM slot by pressing the retaining clips outward.
Step 2.
Align a DIMM on the slot such that the notch on the DIMM matches the
break on the slot.
Step 3.
Firmly insert the DIMM into the slot until the retaining clip snap back in
place and the DIMM is properly seated.
2.3 Expansion Slots (PCI, AMR, a n d AGP Slots)
There are 3 PCI slots and 1 AMR slot on both G Pro and GV Pro motherboards.
Additionally, there is one AGP slot on G Pro.
PCI slots: PCI slots are used to install expansion cards that have the 32-bit PCI
interface.
AMR slot: AMR slot is used to insert an ASRock AMR card with v.92 Modem
functionality.
AGP slot: The AGP slot is used to install a graphics card. The ASRock AGP slot
has a special locking mechanism which can securely fasten
the graphics card inserted.
Installing an expansion c a r d
Step 1. Before installing the expansion card, read the documentation of the
expansion card and make necessary hardware settings for the card.
Step 2. Remove the bracket facing the slot that you intend to use. Keep the
screw for later use.
Step 3. Align the card connector with the slot and press firmly until the card is
completely seated on the slot.
Step 4. Fasten the card to the chassis with screws.
2.4 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "SHORT". If no jumper
cap is placed on the pins, the jumper is
"OPEN". The illustration shows a 3-pin jumper
whose pin 1 and pin2 are "SHORT" when
short
Open
jumper cap is placed on these 2 pins.
Advertisement
