Table of Contents
Advertisement
Section 2 - OPERATING INSTRUCTIONS
2.1 PRE-START CHECK LIST
Make the following checks and perform the service
required before each start-up.
2.1.1. Check guards, deflectors, grass bag, adapter
and covers to make sure all are in place and securely
tightened.
WARNING
DO NOT start or operate this machine without
installing the recycling plug or the entire grass
catcher.
2.1.2. Check blade control and wheel drive control
to insure they work freely. See Figure 2.1.
BLADE CONTROL
FIGURE 2.1
2.1.3. Check cutting height. Adjust to desired height.
2.1.4. Check engine oil and add oil as needed to bring
level up to the full mark. Refer to Engine Owner's
Manual for oil specifications. See Figure 2.2B.
FUEL VALVE
FIGURE 2.2A
WHEEL
DRIVE
CONTROL
OIL
FILL/CHECK
2.1.5. Add fuel to tank after pushing the mower
outside where fumes can safely dissipate. Make sure
cap is tightened after refueling. Refer to Engine
Owners Manual for specifications.
2.1.6. Clean exterior surfaces of cutting deck and
engine of any accumulation of spilled fuel, dirt, grass,
oil, etc. Keep engine air intake screen and cooling
fins clear at all times.
2.2 STARTING & OPERATION
2.2.1. ENGINE & BLADE
(Recoil Start)
1. After first completing Pre-start checklist, turn fuel
valve to "On" position. See Figure 2.2A.
2. Move engine speed control to the "CHOKE"
position. See Figure 2.3.
IMPORTANT: Stop the engine (and blade) by releasing
the blade control.
BLADE
CONTROL
3. Pull blade control against handle.
4. Pull rope start handle to crank engine.
5. After engine starts, move engine speed control to
the "FAST" (Rabbit) position and allow a brief
warm-up until engine runs smooth.
6
FIGURE 2.2B
ENGINE
SPEED
CONTROL
FIGURE 2.3
FUEL
FUEL
CAP
CAP
CHOKE
Advertisement
Table of Contents
