Alcatel-Lucent 500V Series User Manual page 89

$ 7URXEOHVKRRWLQJ
2YHUYLHZ
3XUSRVH
This Appendix provides guidance for troubleshooting. The CPE operation can easily be
monitored via the LED indicators to identify problems. The table below describes
common problems you may encounter and possible solutions.
'LDJQRVLQJ
6\PSWRP
PWR LED
does not light
up after power
on.
DSL LED is
flashing slowly
after making a
connection.
LAN LED does
not light up
after making a
connection.
WLAN LED is
flashing after
wireless
traffic.

 
,VVXH  0D\ 
3RVVLEOH FDXVH
Power outlet, power
cord, or power adapter
may be defective.
The cabling, or the
VDSL port on the CPE
may be defect.
Network interface
(e.g., a network
adapter card in the
attached computer),
network cable, or the
LAN port on the CPE
may be defect or not
connected.
WLAN link off-grade
or the WLAN module
may be defect.
6ROXWLRQ
Check the power outlet by plugging in another
•
device that is functioning properly.
Call the Customer Support Hotline or return
•
the device to the vendor.
Verify that the CPE is powered on.
•
Make sure the cable is correctly plugged into
•
the VDSL line wall outlet and the CPE
connector labeled "VDSL".
Verify that the CPE and the computer device
•
are powered on.
Make sure that the cable is plugged into both,
•
the CPE and the device.
Verify that the proper cable type is used and its
•
length does not exceed specified limits.
Check the network adapter in the device and
•
the cable connections for possible defects.
Replace the defective adapter or cable if
necessary.
Check if the WLAN module is in operation
•
and works properly.
Make sure that the antenna is correctly
•
plugged into the WLAN socket on the CPE.
$