Bissell 2513 Series User Manual page 10

Cleaning with Stain Trapper Tool
WARNING
Keep spray away from face. Failure to do so may result in personal injury.
1
Attach the Stain Trapper
Tool to the end of the hose.
4
Dump dirty water into a
sink or toilet and rinse the
tank out with clean water.
CLEANING THE STAIN TRAPPER TOOL: Clean the front of the tool by removing
the plate over the suction plate. Pull down to remove and rinse with water. Then
replace the plate by sliding back into place.
Cleaning with LED Spraying Crevice Tool
1
Pull tabs out of battery
door area before use
to activate. Connect
to the end of the hose
and the LED Light will
automatically turn on.
Pull the trigger to spray
solution. Scrub and
suction the area to lift
and remove the stain.
10
www.BISSELL.com
2
Slowly move the tool back
and forth over the stain. Be
careful not to move the tool
back and forth too quickly
or soiled water will flow
back into the hose.
5
2
To replace LED battery, unscrew the small
screw with a Phillips-head screwdriver. Pull
cover off to reveal two batteries (CR1632
3V). Slide and pull out each battery and
replace with new. Be sure the "+" sign on
battery is facing out.
Dispose of used battery promptly. Keep
away from children. Do not disassemble and
do not dispose of in fire.
3
To empty the Stain Trapper
Tool, rotate the small tank
on the bottom of the tool
to unlock it.
Replace the tank by
lining up the locking
teeth with their mating
slots (make sure the
two teeth that are
closest together are
pointed toward the
brush). Turn the tank to
lock it into place.