Safety Notice - Baldor LD Series Installation And Operating Manual

Dc servo drive control
Table of Contents

Advertisement

Safety Notice

:
PRECAUTIONS:
1-2 General Information
Servo Systems Co. • 115 Main Road • P.O. Box 97 • Montville, NJ, 07045-0097
This equipment contains high voltages. Electrical shock can cause serious or fatal injury.
Only qualified personnel should attempt the start–up procedure or troubleshoot this
equipment.
This equipment may be connected to other machines that have rotating parts or parts
that are driven by this equipment. Improper use can cause serious or fatal injury. Only
qualified personnel should attempt the start–up procedure or troubleshoot this equipment.
WARNING: Do not touch any circuit board, power device or electrical
connection before you first ensure that power has been
disconnected and there is no high voltage present from this
equipment or other equipment to which it is connected. Electrical
shock can cause serious or fatal injury. Only qualified personnel
should attempt the start–up procedure or troubleshoot this
equipment.
WARNING: Be sure that you are completely familiar with the safe operation of
this equipment. This equipment may be connected to other
machines that have rotating parts or parts that are controlled by
this equipment. Improper use can cause serious or fatal injury.
Only qualified personnel should attempt the start–up procedure or
troubleshoot this equipment.
WARNING: Be sure all wiring complies with the National Electrical Code and all
regional and local codes. Improper wiring may result in unsafe
conditions.
WARNING: Be sure the system is properly grounded before applying power.
Do not apply AC power before you ensure that grounds are
connected. Electrical shock can cause serious or fatal injury.
WARNING: Before servicing this control, allow at least five (5) minutes after AC
power is disconnected to allow capacitors to discharge. Electrical
shock can cause serious or fatal injury.
WARNING: Improper operation of control may cause violent motion of the
motor shaft and driven equipment. Be certain that unexpected
motor shaft movement will not cause injury to personnel or damage
to equipment. Peak torque of several times the rated motor torque
can occur during control failure.
WARNING: Motor circuit may have high voltage present whenever AC power is
applied, even when motor is not rotating. Electrical shock can
cause serious or fatal injury.
WARNING: A DB Resistor may generate enough heat to ignite combustible
materials. To avoid fire hazard, keep all combustible materials and
flammable vapors away from brake resistors.
Continued on next page.
(973) 335-1007 • Toll Free: (800) 922-1103 • Fax: (973) 335-1661
www.servosystems.com
MN1269

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ld2 seriesLd4 seriesLd2-02s

Table of Contents