Sony HT-S350 Operating Instructions Manual page 33

 Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
 Wait a while, and then try again. If
you unplug the Sound Bar, it will take
a while before operations can be
made. Wait for 15 seconds or longer,
and then try again.
 Make sure the devices connected to
the Sound Bar support the Control for
HDMI function.
 Enable the Control for HDMI function
of the devices connected to the
Sound Bar. For details, refer to the
operating instructions of your device.
 The type and number of devices that
can be controlled by the Control for
HDMI function is restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to
3 devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphone): up to 1 device (used by
the Sound Bar)
All indicators on the Bar Speaker
flash for 10 seconds and the Sound
Bar is turned off.
 The protection feature is activated.
Disconnect the AC power cord (mains
lead) and make sure that the
ventilations of the Bar Speaker are
not covered and turn on the Sound
Bar after a while.
Sensors of the TV do not work
properly.
 The Bar Speaker may block some
sensors (such as the brightness
sensor), the remote control sensor of
your TV or the emitter for 3D glasses
(infrared transmission) of a 3D TV that
supports the infrared 3D glass
system, or wireless communication.
Move the Bar Speaker away from the
TV within a range that allows those
parts to operate properly. For the
locations of the sensors and remote
control receiver, refer to the
operating instructions supplied with
the TV.
The Sound Bar does not work
properly.
 The Sound Bar may be in demo
mode. To cancel demo mode, reset
the Sound Bar. Press and hold –
(volume) and  (power) on the Bar
Speaker for more than 5 seconds
(page 34).
The following message appears.
* This screen is an example for English.
 Select the TV program by using the TV
remote control.
33
GB