Technical Information - AEG LAVATHERM 76484AIH User Manual

Problem
Abnormally
elapsing
time on the
display.
Programme
inactive.
Drying cycle
too short.
Drying cycle
too long
1) If there is an error message on the display (e.g. E51): Turn the tumble dryer off and on.
Make a selection of the new programme. Push the Start/Pause button. Does not
operate? - contact the service centre and give the error code.
2) follow the programme description — see PROGRAMMES chapter
3) see CARE AND CLEANING chapter
4) see section WATER HARDNESS in HINTS AND TIPS chapter
5) Only the tumble dryers with drum light.
6) Note: After maximum 5 hours the drying cycle ends automatically (see Drying cycle
complete section).
10.2 Drum internal lamp
This appliance has an internal lamp that
comes on when you open the door and
goes off when the door is closed.
WARNING!
Do not look directly into the
beam of the lamp.

11. TECHNICAL INFORMATION

1)
Possible cause
The time to end is calculated
on the basis of the volume and
dampness of the laundry.
The water container is full.
Too small laundry volume.
The laundry is too dry.
The filter is clogged.
Too high volume of the load.
The laundry not spun sufficient-
6)
ly.
Very high room temperature -
this is not the appliance mal-
function.
Remedy
The automatic procedure —
this is not the appliance mal-
function.
Drain the water container
push the Start/Pause button.
Do the selection of time pro-
gramme. The time value must
be related to the load. To dry
one item or small quantities of
the laundry we recommend to
use short times.
Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry )
Clean the filter.
Obey the maximum load vol-
ume.
Spin correctly the laundry.
If possible, lower the room
temperature.
To replace the internal lamp,
contact the service centre.
Disconnect the mains plug from
the mains socket before the re-
placement of the internal lamp.
ENGLISH
45
3)
,