Specifications - Sony ICP-X7000 Operation Manual

MKS-X7032 Key Fader Module
A module for performing key operations using a fader
lever.
MKS-X7033 Utility/Shotbox Module
An operation module to provide buttons that may be used
as utility buttons or shotbox recall buttons.
MKS-X7035 Key Control Module
An operation module for key adjustments and other
operations.
MKS-X7040 Blank Panel (1/3)
A blank panel of 1/3 unit size to fill parts of the main panel
which are not filled by the modules in its current
configuration.
MKS-X7041 Blank Panel (1/2)
A blank panel of 1/2 unit size to fill parts of the main panel
which are not filled by the modules in its current
configuration.
MKS-X7042 Blank Panel (1/6)
A blank panel of 1/6 unit size to fill parts of the main panel
which are not filled by the modules in it
MKS-X7075 Extension Adaptor
An adaptor which allows modules to be installed apart
from the main panel.
MKS-X7701 Tally/GPI Output Board
An option board that installs into the MKS-X7700 for
tally/GPI output port expansion.
MKS-X7702 Serial Interface Board
An option board that installs into the MKS-X7700 for
remote connector expansion.
22

Specifications

Specifications
Design and specifications are subject to change without
notice.
Notes
• Always verify that the unit is operating properly before
use. SONY WILL NOT BE LIABLE FOR DAMAGES
OF ANY KIND INCLUDING, BUT NOT LIMITED
TO, COMPENSATION OR REIMBURSEMENT ON
ACCOUNT OF THE LOSS OF PRESENT OR
PROSPECTIVE PROFITS DUE TO FAILURE OF
THIS UNIT, EITHER DURING THE WARRANTY
PERIOD OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.
• SONY WILL NOT BE LIABLE FOR CLAIMS OF
ANY KIND MADE BY USERS OF THIS UNIT OR
MADE BY THIRD PARTIES.
• SONY WILL NOT BE LIABLE FOR THE
TERMINATION OR DISCONTINUATION OF ANY
SERVICES RELATED TO THIS UNIT THAT MAY
RESULT DUE TO CIRCUMSTANCES OF ANY KIND.
ICP-X7000 Integrated Control Panel
Pack
General
1)
Power requirements
42.5 V to 57 V (PoE), 12 V DC
2)
Current consumption
0.6 A (PoE), 2.1 A DC
Inrush current (1) Maximum possible inrush current at
initial switch-on (Voltage changes
caused by manual switching):
70 A peak, 10 A r.m.s. (240 V AC)
(2) Inrush current after a mains
interruption of five seconds (Voltage
changes caused at zero-crossing):
10 A peak, 5 A r.m.s. (240 V AC)
Operation guaranteed temperature
5 ºC to 40 ºC (41 ºF to 104 ºF)
Performance guaranteed temperature
10 ºC to 35 ºC (50 ºF to 95 ºF)
Storage temperature
−20 ºC to +60 ºC (−4 ºF to +140 ºF)
Dimensions (w/h/d, excluding projections)
1522 × 140 × 585 mm
(60 × 5
3)
Mass Approx. 39.0 kg (86 lb)
1) Has power supply input connector on each bank.
2) For each bank. Varies depending on the number of module configuration.
3) Varies depending on the number of banks and module configuration.
3)
5 1
/ × 23 / inches)
8 8