Chapter 1. Product Overview 1-1. Introduction to The Wireless LAN Card This wireless LAN (Local Area Network) card is composed of the IEEE 802.11b MAC, Baseband, and radio components, PCMCIA interface, and two built-in antennas. This product adopts the direct sequence spread spectrum (DSSS) technology and the DBPSK, DQPSK, and CCK modulation mode to provide a very stable wireless communication quality and an excellent signal receiver capability.
Max. 95% Non-condensing 4-4. Software Support AP mode firmware Tertiary 1.2.1 Roaming Supports roaming. Security 64 bit WEP (128 bit WEP optional) 4-5. Mechanical Dimensions 88 x 54 x 6 mm Weight 34 g Packaging Packaging specially used by Gigabyte.
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Page 6
20 cm may be maintained between the antenna and users (for example access points, routers, wireless ASDL modems, and similar equipment). The final end product must be labeled in a visible area with the following: “ Contains TX FCC ID: JCK-GN-WLMS502 ”. Manual Information That Must be Included The users manual for end users must include the following information in a prominent location “...