Use Of Combi Detergent Tablets; Use Of Rinse Aid; Adjusting The Rinse Aid Dosage - AEG FAVORIT 35010 VI User Manual

Do these steps to fill the detergent dispenser:
1. Press the release button ( 2 ) to open the detergent dispenser lid ( 7 ).
2. Put the detergent in the dispenser ( 1 ). Follow the dosage recommended by the man-
ufacturer.
3. If the washing programme has a prewash phase, put a small quantity of detergent on
the inner part of the appliance door.
4. If you use detergent tablets, put the detergent tablet in the detergent dispenser ( 1 ).
5. Close the detergent dispenser. Press the lid until it locks into position.
Different brands of detergent dissolve in different times. Some detergent tablets do not
have the best cleaning results during short washing programmes. Use long washing pro-
grammes when you use detergent tablets to fully remove the detergent.

Use of combi detergent tablets

These tablets contain agents such as detergent, rinse aid and dishwasher salt. Some types
of tablets can contain other agents.
When you use tablets, that contain special salt and rinse aid, it is not necessary to fill the
salt and rinse aid containers. In this condition the rinse aid indicator light stays on when
the appliance is switched on.
1. Do a check if these tablets are applicable for the local water hardness. Refer to the
instructions from the manufacturer.
2. Select the lowest setting for the water hardness and rinse aid dosage.
To go back and use separately detergent, salt and rinse aid
1. Fill the salt container and rinse aid dispenser.
2. Adjust the water hardness setting to the highest level.
3. Do a washing programme without dishes.
4. Adjust the water softener to the water hardness in your area.
5. Adjust the rinse aid dosage.

Use of rinse aid

Rinse aid makes it possible to dry the dishes without streaks and stains.
Rinse aid is automatically added during the last rinsing phase.
Do these steps to fill the rinse aid dispenser:
1. Press the release button ( 6 ) to open the rinse aid dispenser lid ( 5 ).
2. Fill the rinse aid dispenser ( 3 ) with rinse aid. The mark 'max.' shows the maximum level.
3. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam during
the washing programme.
4. Close the rinse aid dispenser. Press the lid until it locks into position.

Adjusting the rinse aid dosage

The rinse aid is set at the factory at position 3.
You can set the rinse aid dosage between position 1 (lowest dosage) and position 4 (highest
dosage).
Turn the rinse aid dial ( 4 ) to increase or decrease the dosage.
Use of detergent and rinse aid
33