Mounting Under A Continuous Worktop; Rehingeing The Door - AEG SANTO 1403-4 U Operating Instructions Manual

Mounting under a continuos worktop
Supplied with the appliance is a kit including a venting grille (B) and
two brackets (A) to fix the appliance to the kitchen unit.
Fit the two brackets on the upper hinges (see detail) and fix them
by means of the screws supplied with the kit.
Insert the appliance into the kitchen unit recess and fix the two
brackets to the unit by means of two woodscrews.
Push-fit the front venting grille (B)
in its housing.

Rehingeing the door

Before connecting your appliance to the power supply, you should
check whether the door hinge should be changed over from right (as
delivered) to left if required by the installation site and operability.
Tilt the appliance slightly towards the rear and prop it securely.
Remove bottom hinge (4).
Remove door (3).
Remove pivot (1) from the top hinge and refit it in the outer hole of
the hinge on the opposite side.
Refit the door and the bottom hinge.
Remove handle (2) and refit it on the opposite side.
22
B
A
1
2
3
4