Cisco Unified 500 Series Getting Started page 31

Launch the Cisco Configuration Assistant. For information, see the Getting Started with
Step 2
Cisco Configuration Assistant document at
CD-ROM that shipped with the Cisco Unified 500 Series
Step 3 Using an RJ-45-to-RJ-45 Ethernet cable, connect the Ethernet port of the PC on which the
Cisco Configuration Assistant is installed to a PoE port on the front panel of the Cisco Unified
500 Series.
Step 4 Use the Cisco Configuration Assistant to perform the following tasks. For information, see
online help.
a. Connect to a New Community.
b. Accept the default values to create the initial configuration.
Note If you are installing a single-site key system configuration, change the Voice System
Type setting from PBX to Key System Configuration.
c. Save the configuration.
Step 5 Confirm that the Cisco Unified 500 Series appears in the Topology View.
What to Do Next
The following tasks can be performed in any order:
• To install a Cisco Catalyst Express 520 switch, see the
a Cisco Unified 500 Series" section on page
• To connect the Cisco Unified 500 Series to a WAN, PSTN, or ISDN or to connect devices such as
wireless access options, phones, and PCs, see the
page 39.
• To add and configure locales and languages other than US English on the Cisco Unified 500 Series
and for voice mail prompts, see the
• To modify the software configuration to personalize the Cisco Unified 500 Series with site-specific
values for basic and advanced telephony features, see the
section on page 42
http://www.cisco.com/go/configassist
"Install a Cisco Catalyst Express 520 for
32.
"Connect Interfaces and Devices" section on
"Configure Localization Support" section on page
"Modify the Software Configuration"
or on the
46.
31