AEG SANTO 75320 DT User Manual page 10

- Opening the doors, fix the middle
hinge on the left side with two
screws. Do not forget the plastic
spacer that must be placed under the
middle hinge (H).
- Dismantle the handles, by sliding
the handle-cover, by unscrewing
its side and middle screws and
reassemble them on the opposite
1
side. Cover the holes left open
2
with the plugs contained in the
documentation pack.
Pay attention that the border of the
doors are parallel to the top border.
Reposition, level the appliance and
connect it to the mains socket.
Move the small plug from right to
left..
In any case you do not want to carry
out the above mentioned operations,
contact the nearest After Sales Ser-
vice Force. The After Sales Service
specialist will carry out the
reversibility of the doors at your
cost.
Attention:
After having reversed the opening direction of the doors check that all the
screws are properly tightened and that the magnetic seal adheres to the
cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. in that case, wait for the natural fitting of
the gasket or accelerate this process by heating up the part involved with a
normal hairdrier.
10