Installation; Power Supply - AEG OKO-SANTO Series Operating Instructions Manual

Installation

See installation instructions supplied.
Please check whether, after installing your appliance and especially
after rehingeing the door, the door seal seals right round. An untight
door seal may lead to heavy frosting and thereby to a higher power
consumption (see also „What to do if...").

Power supply

A correctly installed, earthed socket is required for the electrical supply.
The supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electri-
cal installation must include suitable means of isolating the appliance
from the mains (e.g. fuse, cut-out, current trip or similar with a mini-
mum contact separation of 3 mm).
0 Before initial start-up, refer to the appliance serial plate to ascertain if
supply voltage and current values correspond with those of the mains
at the installation location.
e.g.:
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
The mains cable may only be changed by a qualified electrician. If your
appliance needs repairing, please contact our Customer Service.
36
AC 220 ... 240 V 50 Hz or
220 ... 240 V ~50 Hz